Genlly, in the hydropower transformation, the original water pipes will be replaced. Home improvement companies and businesses recommend that all decorators use hot water pipes whe
Jul 06, 2021
The PPR tubes sold on the market mainly have the following colors, white, gray, green and curry. Why is there this difference? It is mainly caused by the different color masterbatc
Genlly, there will be no more water leakage, and the reliability is extremely high. But this is not to say that PPR water pipes are flawless water pipes, with poor high tempture re
Jul 05, 2021
1. How much pressure can the ppr tube bear? According to national regulations, PPR pipes can withstand a maximum pressure of 16MPa (megapascals). (1 MPa = 10 kg/cm²). 2. It depends
Under normal circumstances, pe pipes cannot be connected by heat fusion, while ppr pipes can be connected by heat fusion, so pe pipes and ppr pipes can be connected by...
Jun 30, 2021
In normal life, sometimes you find that the faucet still drips after being tightened, and it drips from the faucet outlet or the joint, which not only causes a lot of waste, but so
Look at the brightness The surface chromium plating process of a good faucet is very particular, and it is usually completed through sevl processes. To distinguish the quality of t
Weight: You can't buy a faucet that is too light. Too light is mainly because the manufacturer hollowed out the internal copper in order to reduce costs. The faucet looks large
The difference between copper ball valve and stainless steel ball valve: 1. They use completely different materials. The steel ball valve uses copper, and the stainless steel ball
Brass ball valves are mainly used to cut off or connect the medium in the pipeline, and can also be used for fluid adjustment and control. Among them, the hard-sealed V-shaped ball
Depending on the situation, if there is water leakage at the interface, you need to replace the rubber pad or tighten the loose screw at the interface. If the outlet pipe is leakin
Some angle valves are divided into hot and cold water. The angle valve for cold and hot water is not necessary and can be omitted, but the angle valve is installed so that if there
