Cleverly take the broken thread male in the PPR Female elbow of PPR systerm

With the general improvement of people's living standards, the water supply pipes are buried in the wall and installed in the wall for the sake of beauty during the decoration of civil houses. When the triangular water valve is replaced after a few years of staying, it is often Because the triangle valve thread is broken in the inner elbow of the water pipe and the wall is cut to replace the water pipe elbow, it is costly, unsightly, and time-consuming and laborious. Now introduce a method to easily remove the broken wire in the inner elbow of the water pipe The tooth method is as follows: buy a hacksaw blade, extend the hacksaw blade into the wire tooth in the broken inner tooth elbow, saw two seams on the wire tooth with a spacing of 0.5cm~1cm wide, and then use a steel sharp Use the appliance to gently pry the 0.5cm~1cm wide wire teeth, and the small pieces of wire teeth will fall out, and then pry the wire teeth on both sides. Take out all the teeth. The whole process takes about half an hour. Be careful not to damage the inner teeth of the water pipe elbow when the hacksaw blade is sawed.